With the continuous development of industry and mining, the machinery industry is also undergoing transformation. Raymond mill has always been an important part of minerals, chemicals, and building materials in the field of mechanical equipment, but various problems will inevitably occur during use. Raymond mill is one of the widely used equipment in the crushing industry. According to statistics from industry authorities, Raymond mills account for as much as 70% of domestic milling equipment. However, as the production progresses, the powder rate will decrease, which will affect the production efficiency.
Raymond Mill
Raymond mill material damp
The powder locker is not tightly sealed
Analyzer doesn't work
The fan is not adjusted properly
blade failure

Raymond Mill
With the continuous development of industry and mining, the machinery industry is also undergoing transformation. Raymond mill has always been an important part of minerals, chemicals, and building materials in the field of mechanical equipment, but various problems will inevitably occur during use.
Raymond mill is one of the widely used equipment in the crushing industry. According to statistics from industry authorities, Raymond mills account for as much as 70% of domestic milling equipment. However, as the production progresses, the powder rate will decrease, which will affect the production efficiency.

Here are some reasons why the powder yield is low:

Raymond mill material damp
On the one hand, if the material is damp, it will block the discharge port, resulting in difficulty in powder discharge. On the other hand, in the selection of materials, try to choose moderate hardness, which is more suitable for Raymond mill materials, so as to prevent the materials from being too hard and difficult to realize the grinding operation.

The powder locker is not tightly sealed

If the powder locking machine is not properly sealed during the grinding process of the Raymond mill, it will cause powder back suction, resulting in no powder or less powder output. Therefore, check the sealing of the powder locking machine and adjust the sealing degree.

Analyzer doesn't work
The analysis machine of the Raymond mill is responsible for analyzing the size of the finished powder, whether it meets the finished product standard, and whether it needs to be re-grinded. In the case of severe wear and tear of the blades of the analyzer, it cannot play the role of classification, which will cause the powder to be too coarse or too fine. In this case, it can be solved by replacing the blade with a new one.

The fan is not adjusted properly

If the air volume of the Raymond mill fan is not adjusted properly, the air volume is too large, which will also cause abnormal powder output from the pulverizer. , to correct the powder particle size.
 

blade failure
Raymond grinding shovel is responsible for scooping up materials. When the shovel is used for a period of time or the quality is not good enough, it will be worn out and the material will not be shoveled. It will also cause no powder or less powder, which needs to be replaced. New blades to keep the equipment running properly.
The above is the solution to the abnormal powder output of the Raymond mill. If you want to know more about the Raymond mill, please leave a message.